Tray Specs
Tray Specifications
If you require assistance please contact
Regions: National, NSW, QLD
TILTIP Head Quarters
Email: Tony Hall
Phone: 0412 723 523
To obtain a quote please email us at tiltatony@bigpond.com or tiltatam@bigpond.com
Note; Standard Tiltip Body Weight Estimates will vary according to tray length and Tiltip design preferences. Make allowance for weight & Cost of all vehicle accessories.
It is recommended clients discuss their choice of make model cab chassis, nominating specific Tiltip design requirements and all vehicle accessories, in light of anticipated payload requirements and likely operating environments.
For Tray Specification select appropriate Body Operating Capacity below.
3 - 4 Tonnes
General Specifications 3-4 Tonnes
Approximate Tiltip Body weight 1500 kg
Desired Wheel Base Range; From-To 3800-5000
Chassis Frame 65x65x4 shs
Under Body Rams single double action hydraulic
Vesconite Bearing Pivot Rollers standard throughout all pivot points and rollers on all models
Parallel Flange Channels – tray frame 125 pfc
SHS Crossmembers 65x65x4 shs
Hardox ( high tensile ) floor 3 mm
Plate Steel Sides 3 mm
Tailgate hinged and swung tailgate standard throughout all models
PTO generally Powauto electric switch
In Cab Tipping Control in cab electric switch
In Cab Tilt Control in cab electric switch
Tray Length 4.3 – 6.0 m
Tray Side Height 250-500 mm
Head Board cab height plate steel with vertical rhs frame
Floor traction Lugs and 4 Flush Mounted Tie Down Plates standard throughout all models
Oversize Oil Tank and Filter standard throughout all models